3Com Switch 8800 Family Command Reference Guide

350 CHAPTER 21: AAA AND RADIUS/HWTACACS PROTOCOL CONFIGURATION COMMANDS
Example
# Set the quiet timer of the primary server to 10 minutes.
[SW8800] radius scheme test1
[3Com-radius-test1] timer quiet 10
timer
realtime-accounting
Syntax
timer realtime-accounting minute
undo timer realtime-accounting
View
RADIUS scheme view
Parameter
minute: Real-time accounting interval, ranging from 3 to 60 and measured in
minutes. It must be a multiple of 3.By default, the value is 12.
Description
Use the timer realtime-accounting command to configure the real-time
accounting interval.
Use the undo timer realtime-accounting command to restore the default
interval.
To implement real-time accounting, it is necessary to set a real-time accounting
interval. After the attribute is set, NAS will transmit the accounting information of
online users to the RADIUS server regularly.
The value of minute is related to the performance of NAS and RADIUS server. The
smaller the value is, the higher the requirement for NAS and RADIUS server is.
When there are a large amount of users (more than 1000, inclusive), we suggest a
larger value. The following table recommends the ratio of minute value to number
of users.
Related command: retry realtime-accounting , radius scheme.
Example
# Set the real-time accounting interval of RADIUS scheme, "3com", to 15
minutes.
[3Com-radius-3com] timer realtime-accounting 15
Tabl e 44 Recommended ratio of minute to number of users
Number of users Real-time accounting interval (in minutes)
1 to 99 3
100 to 499 6
500 to 999 12
‚â•1000 ‚â•15