3Com Switch 8800 Family Command Reference Guide

434 CHAPTER 25: OSPF CONFIGURATION COMMANDS
display ospf routing Syntax
display ospf [ process-id ] routing
View
Any view
Parameter
process-id: ID of an OSPF process. The command is applied to all current OSPF
processes if you do not specify a process ID.
Description
Use the display ospf routing command to view information about the OSPF
routing table.
Example
# View the OSPF routing table.
<SW8800> display ospf routing
OSPF Process 1 with Router ID 1.1.1.1
Routing Tables
Routing for Network
Destination Cost Type NextHop AdvRouter Area
10.110.0.0/16 1 Net 10.110.10.1 1.1.1.1 0
10.10.0.0/16 1 Stub 10.10.0.1 3.3.3.3 0
Total Nets: 2
Intra Area: 2 Inter Area: 0 ASE: 0 NSSA: 0
Tabl e 65 Description of the fields of the display ospf retrans-queue command
Field Description
RouterID Router ID of neighbor router
Address Address of the interface, through which neighbor routers communicate with the
router
Interface Address of the interface on the network segment
Area Number of an OSPF area
Type Type of the LSA
LSID Link State ID of the LSA
AdvRouter Router ID of the router originating the LSA
Tabl e 66 Description of the fields of the display ospf routing command
Field Description
Destination Destination network segment
Cost Cost of route
Type Type of route
NextHop Next hop of route
AdvRouter Router ID of the router advertising the route
Area Area ID
Intra Area Number of intra-area routes
Inter Area Number of inter-area routes
ASE Number of external routes