3Com Switch 8800 Family Command Reference Guide

BGP Configuration Commands 509
Description
Use the display bgp peer command to view the information about BGP peers.
Example
# Display the detail information of the peer 201.1.1.2.
<SW8800> display bgp peer 201.1.1.2 verbose
Peer: 201.1.1.2+179 Local: 200.1.1.1+1195
Type: External
State: Established Flags: <>
Expiring Time: 00:02:19
Last State: OpenConfirm Last Event: RecvKeepAlive
Last Error: None
Options: <KeepAll Ttl>
Peer Version: 4 Peer ID: 201.1.1.2 Local ID: 200.1.1.1
Active Holdtime: 180s, Keepalive: 60s
Last traffic (seconds): Received 41 Sent 41 Checked 41
Input messages: Total 4 Updates 1 Octets 125
Output messages: Total 4 Updates 1 Octets 148
Route Queue Timer: unset
Peer capabilities:
Route refresh: advertised and received
Ipv4-family Unicast: advertised and received
Configuration within the peer :
no export policy route-policy
no export policy ip-prefix
no export policy filter-policy
no export policy acl
no import policy route-policy
no import policy ip-prefix
no import policy filter-policy
no import policy acl
no default route produce
display bgp
routing-table
Syntax
display bgp routing-table [ ip-address [ mask ] ]
View
Any view
Tab le 73 Description of the fields of the display bgp peer verbose command
Field Description
Peer IP address of peer and port number used by the peer to establish TCP connection
Local IP address and port number used to establish TCP connection of local end
Type Type of peer: Internal for IBGP, and External for EBGP
State State of peer
Flags Flags of peer
Last State Last state before entering the current state
Last Event Last event of neighbor state machine
Last Error Last error of neighbor state machine
Options Options