3Com Switch 8800 Family Command Reference Guide

790 CHAPTER 43: VRRP CONFIGURATION COMMANDS
Description
Use the display vrrp command to view the information about the VRRP state.
If the interface name and virtual router ID are not specified, the state information
about all the virtual routers on the switch will be displayed. If only the interface
name is specified, the state information about all the virtual routers on the
interface will be displayed. If the interface name and virtual router ID are specified,
the state information about the specified virtual router on the interface will be
displayed.
Example
# Display the VRRP state information on VLAN-interface 1.
[3Com-Vlan-interface1] display vrrp interface vlan-interface 1
Run Method : VIRTUAL-MAC
Virtual Ip Ping : Disable
Interface : Vlan-interface1
VRID : 1 Adver. Timer : 1
Admin Status : UP State : Initialize
Config Pri : 100 Run Pri : 90
Preempt Mode : YES Delay Time : 0
Auth Type : NONE
Track IF : Vlan-interface2 Pri Reduced : 10
Virtual IP : 1.1.1.1
Master IP : 0.0.0.0
display vrrp ifm Syntax
display vrrp ifm
View
Any view
Tabl e 100 Description on the fields of the display vrrp command
Field Description
Run Method Run method: real or virtual MAC method
Virtual IP ping Whether to enable to ping through virtual IP
Interface Interface in which virtual router resides
VRID ID of virtual router
Adver.Timer Interval for sending vrrp packets
Admin Status Control status of virtual router
State Running state of virtual router
Config Pri Configured priority
Run Pri Run priority
Preempt Mode Preempt mode
Delay Time Delay time
Auth Type Authentication type
Virtual IP Virtual IP address list of virtual router
Master IP IP address of the master device in virtual router