3Com Switch 8800 Family Command Reference Guide

SNMP Configuration Commands 905
Example
# Display the information of all the current users.
<SW8800> display snmp-agent usm-user
User name: NotifyV3
Group name: NotifyGroup
Authencation Mode: sha
Privacy Mode: des
Engine ID: 800007DB00E0FC2085026877 active
User name: publicV3
Group name: groupV3
Authencation Mode: no
Privacy Mode: no
Engine ID: 800007DB00E0FC2085026877 active
Acl:2000
The following table describes the output fields.
enable snmp trap Syntax
enable snmp trap updown
undo enable snmp trap updown
View
Ethernet port view / VLAN interface view
Parameter
None
Description
Use the enable snmp trap updown command to enable current port or VLAN
interface to transmit the LINK UP and LINK DOWN trap messages.
Use the undo enable snmp trap updown command to disable current port or
VLAN interface to transmit the LINK UP and LINK DOWN trap messages.
The enable snmp trap command should be used in cooperation with the
snmp-agent trap enable and the snmp-agent target-host commands. The
snmp-agent target-host command is used to specify which hosts can receive the
trap messages. To enable the transmitting of trap messages, you must execute the
snmp-agent target-host command at least once.
Tab le 128 Description on the fields of the display snmp-agent usm-user command
Field Description
User name Character string identifying the SNMP user
Group name Character string identifying the group the user belongs to
Authencation
Mode
Authentication code
Privacy Mode Personal code
Engine ID Character string identifying the SNMP device
Acl Character string identifying the access control list