3Com Switch 8800 Family Configuration Guide

QoS Configuration 191
The system provides default mapping tables.
Configuring traffic parameters (optional)
Use the following command to set the traffic parameters required before
configuring traffic policing on service processor cards.
c
CAUTION: This operation is not required for configuring traffic policing on
common cards.
Perform the following configuration in system view.
Configuring traffic policing
The purpose of this configuration task is to implement traffic policing on
ACL-matched data streams, and then take normal actions on data streams within
the traffic limit and take other actions (discarding packets, for example) on those
exceeding the limit.
For interface cards, perform the following configurations in Ethernet port view.
Restore the default values of the DSCP +
Conform-Level -> Service parameters
mapping table (conform level view)
undo dscp dscp-list
Configure the EXP + Conform-Level -> Service
parameters mapping table (conform level
view)
exp exp-list : dscp-value exp-value cos-value
local-precedence-value drop-precedence
Restore the default values of the EXP +
Conform-Level -> Service parameters
mapping table (conform level view)
undo exp exp-list
Configure the Local-precedence +
Conform-Level -> mapping table (conform
level view)
local-precedence cos-value0 cos-value1
cos-value2 cos-value3 cos-value4 cos-value5
cos-value6 cos-value7
Restore the default values of the
Local-precedence + Conform-Level ->
mapping table (conform level view)
undo local-precedence
Table 162 Configure mapping table
Operation Command
Tab le 163 Configure traffic parameters
Operation Command
Configure traffic parameters
traffic-params traffic-index cir
commited-info-rate cbs commited-base-size
ebs exceed-base-size [ pir peak-info-rate ]
Tab le 164 Configure traffic policing
Operation Command
Configure traffic policing
which only applies IP group
ACL
traffic-limit inbound ip-group { acl-number | acl-name } [
rule rule [ system-index index ] ] [ tc-index index ] cir cbs ebs
[ pir ] [ conform { { remark-cos | remark-drop-priority }* |
remark-policed-service } ] [ exceed { forward | drop } ]
Remove traffic policing
setting which only applies IP
group ACL
undo traffic-limit inbound ip-group { acl-number | acl-name
} [ rule rule ]