3Com Switch 8800 Family Configuration Guide

QoS Configuration 195
However, you are not recommended to assign a system index if not urgently
necessary.
n
■ For MPLS packets, other than that the dscp-value stands for their DSCP priority
value, the dscp-value is also mapped to the EXP. You set the EXP value when
defining the dscp-value. Note that when the Switch 8800 Family switch is used
as the ingress PE: for IP packets, EXP is matched according to the
"DSCP+Conform-Level -> Service parameters" mapping table; for TCP and
UDP packets, the value of EXP is the lower 3 bits of dscp-value. When the
Switch 8800 Family switch is used as ingress P, the value of EXP is the lower 3
bits of dscp-value.
■ The DSCP + Conform-Level 0 -> Service parameters mapping table and the EXP
+ Conform-Level -> Service parameters mapping table (the mapping table for
conform level 0) is used here.
See the corresponding Command Manual for details of the commands.
Configuring Traffic
Redirection
Traffic redirection changes packet forwarding direction, to CPU, other ports, other
IP addresses or other cards.
For interface cards, perform the following configurations in Ethernet port view.
Tab le 169 Configure traffic redirection
Operation Command
Configure traffic redirection
which only applies IP group
ACL
traffic-redirect inbound ip-group { acl-number | acl-name }
[ rule rule [ system-index index ] ] { cpu | interface
interface-type interface-number destination-vlan { l2-vpn |
l3-vpn } | next-hop ip-addr1 [ ip-addr2 ] [ invalid { forward
| drop } ] | slot slotid { vlanid | designated-vlan vlanid } [
join-vlan ] }
Remove traffic redirection
setting which only applies IP
group ACL
undo traffic-redirect inbound ip-group { acl-number |
acl-name } [ rule rule ]
Configure traffic redirection
which applies IP group ACL
and link group ACL at same
time
traffic-redirect inbound ip-group { acl-number | acl-name }
[ rule rule ] link-group { acl-number | acl-name } [ rule rule ] {
cpu | interface interface-type interface-number
destination-vlan { l2-vpn | l3-vpn } | next-hop ip-addr1 [
ip-addr2 ] [ invalid { forward | drop } ] | slot slotid
designated-vlan vlanid [ join-vlan ] }
Remove traffic redirection
setting which applies IP group
ACL and link group ACL at
same time
undo traffic-redirect inbound ip-group { acl-number |
acl-name } { rule rule link-group { acl-number | acl-name } [
rule rule ] | link-group { acl-number | acl-name } rule rule } or
undo traffic-redirect inbound link-group { acl-number |
acl-name } { rule rule ip-group { acl-number | acl-name } |
ip-group { acl-number | acl-name } rule rule }
Configure traffic redirection
which only applies link group
ACL
traffic-redirect inbound link-group { acl-number |
acl-name } [ rule rule [ system-index index ] ] { cpu |
interface interface-type interface-number destination-vlan {
l2-vpn | l3-vpn } | next-hop ip-addr1 [ ip-addr2 ] [ invalid {
forward | drop } ] | slot slotid designated-vlan vlanid [
join-vlan ] }