3Com Switch 8800 Family Configuration Guide

300 CHAPTER 30: RIP CONFIGURATION
Before configuring MD5 authentication, you must configure MD5 type. The usual
packet format follows RFC1723 and the nonstandard follows RFC2082.
Displaying and
Debugging RIP
After the above configuration, execute the display command in any view to
display the running of the RIP configuration, and to verify the effect of the
configuration. Execute the debugging command in user view to debug the RIP
module. Execute the reset command in RIP view to reset the system configuration
parameters of RIP.
Typical RIP
Configuration
Example
Network requirements
As shown in Figure 72, the Switch 8800 Family series routing switch C connects to
the subnet 117.102.0.0 through the Ethernet port. The Ethernet ports of the
Switch 8800 Family series routing switches A and Switch B are respectively
connected to the network 155.10.1.0 and 196.38.165.0. Switch C, Switch A and
Switch B are connected via Ethernet 110.11.2.0. Correctly configure RIP to ensure
that Switch C, Switch A and Switch B can interconnect with each other.
Disable RIP-2 packet authentication undo rip authentication-mode
Table 268 Set RIP-2 packet authentication
Operation Command
Tabl e 269 Display and debug RIP
Operation Command
Display the current RIP running state and configuration
information.
display rip
Enable the RIP packet debugging information debugging rip packet
Disable the RIP packet debugging information undo debugging rip packet
Enable the debugging of RIP receiving packets debugging rip receive
Disable the debugging of RIP receiving packets undo debugging rip receive
Enable the debugging of RIP sending packet debugging rip send
Disable the debugging of RIP sending packet undo debugging rip send
Reset the system configuration parameters of RIP reset