3Com Switch 8800 Family Configuration Guide

Troubleshooting RIP Faults 301
Network diagram
Figure 72 Network diagram for RIP configuration
Configuration procedure
n
The following configuration only shows the operations related to RIP. Before
performing the following configuration, make sure the Ethernet link layer can
work normally.
1 Configure Switch A
# Configure RIP
[Switch A] rip
[Switch A-rip] network 110.11.2.0
[Switch A-rip] network 155.10.1.0
2 Configure Switch B
# Configure RIP
[Switch B] rip
[Switch B-rip] network 196.38.165.0
[Switch B-rip] network 110.11.2.0
3 Configure Switch C
# Configure RIP
[Switch C] rip
[Switch C-rip] network 117.102.0.0
[Switch C-rip] network 110.11.2.0
Troubleshooting RIP
Faults
Symptom: The Switch 8800 Family series cannot receive the update packets
when the physical connection to the peer routing device is normal.
Ethernet
110.11.2.2/24
Network address:
117.102.0.0/16
Network address:
196.38.165.0/24
Interface address:
110.11.2.1/24
Interface address:
117.102.0.1/16
Interface address:
155.10.1.1/24
Network address:
155.10.1.0/24
Interface address:
196.38.165.1/24
SwitchA
SwitchB
SwitchC
Interface address:
110.11.2.3/24
Interface address: