3Com Switch 8800 Family Configuration Guide

382 CHAPTER 33: BGP CONFIGURATION
n
Load balancing is not available for BGP default routes.
Perform the following configuration in BGP view.
By default, the BGP does not implement load balancing.
Setting the Switch for
Adjacency State Output
When the switch for adjacency state output is enabled, the BGP adjacency state
changes will be output to the configured terminal until the switch for adjacency
state output is disabled.
Perform the following configuration in BGP view.
Clearing BGP Connection After the user changes BGP policy or protocol configuration, they must cut off the
current connection so as to enable the new configuration.
Perform the following configuration in user view.
Refreshing BGP Routes It is required to re-compute associated route information when BGP routing policy
changes.
Perform the following configuration in user view.
Tabl e 388 Enable/disable BGP load balancing
Operation Command
Enable BGP load balancing balance balance-number
Disable BGP load balancing undo balance
Tabl e 389 Set the switch for BGP adjacency state output
Operation Command Description
Enter system view system-view -
Enter BGP view bgp as-number Required
Enable the switch for
adjacency state output
log-peer-change
The BGP peer changes are not
reported by default
Tabl e 390 Clear BGP connection
Operation Command
Clear the connection between BGP and the specified peers reset bgp peer-address
Clear all connections of BGP reset bgp all
Clear the connections between the BGP and all the
members of a group
reset bgp group group-name
Tabl e 391 Refresh BGP routes
Operation Command
Refresh general BGP routes
refresh bgp { all | peer-address | group group-name } [
multicast | vpn-instance instance-name | vpnv4 ] { import
| export }