3Com Switch 8800 Family Configuration Guide

User Interface Configuration 47
Configuring Redirection Send command
The following command can be used for sending messages between user
interfaces.
Perform the following configuration in user view.
Auto-execute command
The following command is used to automatically run a command after you log in.
After a command is configured to be run automatically, it will be automatically
executed when you log in again.
This command is usually used to automatically execute telnet command on the
terminal, which will connect the user to a designated device automatically.
Perform the following configuration in user interface view.
Note the following points:
■ After executing this command, the user interface can no longer be used to
carry out the routine configurations for the local system. Use this command
with caution.
■ Make sure that you will be able to log in to the system in some other way and
cancel the configuration, before you use the auto-execute command
command and save the configuration.
# Telnet 10.110.100.1 after the user logs in through VTY0 automatically.
[3Com-ui-vty0] auto-execute command telnet 10.110.100.1
When a user logs on via VTY 0, the system will run telnet 10.110.100.1
automatically.
Configure to permit call-in and call-out. modem both
Configure to disable call-in and call-out undo modem both
Table 25 Configure Modem attributes
Operation Command
Tab le 26 Configure to send messages between different user interfaces.
Operation Command
Configure to send messages between
different user interfaces.
send { all | number | type number }
Tab le 27 Configure to automatically run the command
Operation Command
Configure to automatically run the command auto-execute command text
Configure not to automatically run the command undo auto-execute command