3Com Switch 8800 Family Configuration Guide

52 CHAPTER 6: CONFIGURATION FILE MANAGEMENT
n
The configuration files are displayed in their corresponding saving formats.
Modifying and Saving
the
Current-Configuration
You can modify the current configuration of the switch through the CLI. Use the
save command to save the current-configuration in the Flash Memory, and the
configurations will become the saved-configuration when the system is powered
on for the next time.
Perform the following configuration in user view.
Even if the problems like reboot and power-off occur during , the configuration
file can be still saved to Flash.
Erasing Configuration
Files from Flash Memory
The reset saved-configuration command can be used to erase configuration
files from Flash Memory. The system will use the default configuration parameters
for initialization when the switch is powered on for the next time.
Perform the following configuration in user view.
You may erase the configuration files from the Flash in the following cases:
■ After being upgraded, the software does not match with the configuration
files.
■ The configuration files in flash are damaged. (A common case is that a wrong
configuration file has been downloaded.)
Configuring the Name of
the Configuration File
Used for the Next
Startup.
Perform the following configuration in user view.
Tabl e 29 Display the configurations of the switch
Operation Command
Display the saved-configuration information
of the switch
display saved-configuration
Display the current-configuration information
of the Ethernet switch
display current-configuration [ controller |
interface interface-type interface-number |
configuration [ configuration ] ] [ | { begin |
exclude | include } regular-expression ]
Display the running configuration of the
current view
display this
Tabl e 30 Save the current-configuration
Operation Command
Save the current-configuration save [ file-name ]
Tabl e 31 Erase configuration files from Flash Memory
Operation Command
Erase configuration files from Flash Memory reset saved-configuration