3Com Switch 8800 Family Configuration Guide

638 CHAPTER 52: VPLS CONFIGURATION
NPE
It is a core PE device, located at the edge of the VPLS core network. It provides
VPLS transparent transmission service in the core network.
VSI Through virtual switching instance (VSI) you can map the actually connected links
to each virtual links.
VPLS Basic
Configuration
VPLS Configuration
Tasks
Tabl e 569 VPLS configuration tasks
Operation Command Description
Configure routing protocol
for public network
Refer to the related sections in
Operation Manual - Routing
Protocol
Required
Configure basic MPLS
functions
Refer to chapter 2
Configuring MPLS Basic
Functions in Operation
Manual - MPLS
Required
Configure LDP expansion
session peer
mpls ldp remoter-peer
index
Required
Enabling L2VPN mpls l2vpn Required
Configure a VPLS instance vsi vsi-name [ static ]
Required. static is required
for configuring a VSI.
Configure an IP address of a
peer PE
peer peer-ip [ vc-id vc-id ] [
upe | dual-npe ] [
encapsulation { ethernet |
vlan } ]
Required
Configure static MAC
addresses
mac-address { static H-H-H }
vsi vsi-name { peer peer-ip |
vlan-interface
vlan-interface-number }
Optional
Configure VLAN for user
access and binding VSI
l2 binding vsi vsi-name [
access-mode { vlan |
ethernet } ]
Required
Configure VPLS characteristics bandwidth bw-limit Optional
Enable VLAN VPN (Q-in-Q) on
port
vlan-vpn enable Optional
Configure user-defined flow
template
flow-template
user-defined slot slotnum
template-info
Required
Configure ACL rules
rule rule-id permit mpls
l2label-range ingress any
egress any
Required
Configure packet redirection
traffic-redirect inbound
link-group { acl-number |
acl-name } [ rule rule [
system-index index ] ] | slot
slotid vlanid [ join-vlan ] }
Required
Enable VPSL load sharing vpls-load-share enable Optional