3Com Switch 8800 Family Configuration Guide

VPLS Basic Configuration 639
Configuring Routing
Protocols
You must perform some basic routing configuration on your switch such that it
can exchange routing information with other P and PE devices. Currently, you can
choose the following routing protocols: static routing, routing information
protocol (RIP), open shortest path first (OSPF), exterior border gateway protocol
(EBGP), and so on. For specific configuration, refer to Switch 8800 Family Series
Routing Switches Operation Manual - Routing Protocol.
Configuring Basic MPLS
Functions
Configure basic MPLS functions to create LSP tunnels over public network. For
specific configuration, refer to the "MPLS" section in 3Com Switch 8800 Family
Series Routing Switches Operation Manual Volume I.
Configuring LDP
Expansion Session Peer
Configure LDP remote peer to set up LDP remote session.
Entering the remote-peer mode
Perform the following configuration in system view.
By default, no remote peer exists.
Configuring an address for the remote peer
You can specify any LDP-enabled interface address of a remote peer device or the
loopback address of a label switch router (LSR) that has advertised its routing
information as the address of the remote peer.
Perform the following configuration in remote-peer view.
Enabling L2VPN Enable L2VPN globally before you configure VPLS and VLL; otherwise you cannot
configure VPLS and VLL.
Perform the following configuration in system view.
By default, MPLS L2VPN is disabled.
Tab le 570 Enter the remote-peer mode
Operation Command
Enter the remote-peer mode mpls ldp remote-peer index
Remove the remote peer undo mpls ldp remote-peer index
Tab le 571 Configure an address for the remote peer
Operation Command
Configure an address for the remote peer remote-ip remoteip
Tab le 572 Enable L2VPN
Operation Command
Enable MPLS L2VPN mpls l2vpn
Disable MPLS L2VPN undo mpls l2vpn