3Com Switch 8800 Family Configuration Guide

804 CHAPTER 70: FTP&TFTP CONFIGURATION
Displaying and
Debugging FTP Server
After the above configuration, execute display command in any view to display
the running of the FTP Server configuration, and to verify the effect of the
configuration.
The display ftp-server command can be used for displaying the configuration
information about the current FTP server, including the maximum amount of users
supported by FTP server and the FTP connection timeout. The display ftp-user
command can be used for displaying the detail information about the connected
FTP users.
Disconnecting an FTP
User
Perform the following configuration in system view.
Introduction to FTP
Client
As an additional function provided by the switch, FTP client is an application
module and has no configuration functions. The switch connects the FTP clients
and the remote server and inputs the command from the clients for corresponding
operations (such as creating or deleting a directory).
FTP Client Configuration
Example
Network requirements
The switch serves as FTP client and the remote PC as FTP server. The configuration
on FTP server: Configure an FTP user named as switch, with password hello and
with read & write authority over the Switch root directory on the PC. The IP
address of a VLAN interface on the switch is 1.1.1.1, and that of the PC is 2.2.2.2.
The switch and PC are reachable.
The switch application switch.app is stored on the PC. Using FTP, the switch can
download the switch.app from the remote FTP server and upload the vrpcfg.cfg to
the FTP server under the switch directory for backup purpose.
Network diagram
Figure 188 Network diagram for FTP configuration
Tabl e 757 Display and debug FTP Server
Operation Command
Display FTP server display ftp-server
Display the connected FTP users. display ftp-user
Tabl e 758 Disconnect an FTP user
Operation Command
Disconnect an FTP user. ftp disconnect user-name
Switch
PC
Network
SwitchSwitch
PC
Network