3Com Switch 8800 Family Configuration Guide

Information Center Function 817
4 Sending the configuration information to the log buffer
5 Sending the configuration information to the trap buffer
Tab le 767 Send the configuration information to the monitor terminal
Device Configuration Default value
Configuration
description
Switch
Enable information
center
By default, information
center is enabled
Other configurations are
valid only if the
information center is
enabled
Set the information
output direction to the
monitor
- -
Set information source -
You can define which
modules and information
to be sent out and the
time-stamp format of
information, and so on.
You must turn on the
switch of the
corresponding module
before defining output
debugging information
Enable the terminal
display function and this
function for the
corresponding
information
-
For Telnet terminal and
dumb terminal, to view
the information, you
must enable the current
terminal display function
using the terminal
monitor command
Tab le 768 Send the configuration information to the log buffer
Device Configuration Default value
Configuration
description
Switch
Enable information
center
By default, information
center is enabled
Other configurations are
valid only if the
information center is
enabled
Set the information
output direction to the
logbuffer
-
You can configure the
size of the log buffer at
the same time.
Set information source -
You can define which
modules and information
to be sent out and the
time-stamp format of
information, and so on.
You must turn on the
switch of the
corresponding module
before defining output
debugging information