3Com Switch 8800 Family Configuration Guide

818 CHAPTER 71: INFORMATION CENTER
6 Sending the configuration information to SNMP
Tabl e 769 Send the configuration information to the trap buffer
Device Configuration Default value
Configuration
description
Switch
Enable information
center
By default, information
center is enabled
Other configurations are
valid only if the
information center is
enabled
Set the information
output direction to the
trapbuffer
-
You can configure the
size of the trap buffer at
the same time
Set information source -
You can define which
modules and information
to be sent out and the
time-stamp format of
information, and so on.
You must turn on the
switch of the
corresponding module
before defining output
debugging information
Tabl e 770 Send the configuration information to SNMP
Device Configuration Default value
Configuration
description
Switch
Enable information
center
By default, information
center is enabled
Other configurations
are valid only if the
information center is
enabled
Set the information
output direction to
SNMP
- -
Set information source -
You can define which
modules and
information to be sent
out and the time-stamp
format of information,
and so on. You must
turn on the switch of
the corresponding
module before defining
output debugging
information
Configure SNMP
features
-
Refer to Chapter
"SNMP"
Network
management
workstation
The same as the SNMP
configuration of the
switch
- -