3Com Switch 8800 Family Configuration Guide

Information Center Function 819
Sending the
Configuration
Information to the
Loghost
To send configuration information to the loghost, follow the steps below:
1 Enabling information center
Perform the following configuration in system view.
n
Information center is enabled by default. After information center is enabled,
system performances are affected when the system processes much information
because of information classification and outputting.
2 Configuring to output information to the loghost
Perform the following configuration in system view.
Note that the IP address of log host must be correct.
n
Ensure to enter the correct IP address using the info-center loghost command to
configure loghost IP address. If you enter a loopback address, the system prompts
of invalid address appears.
3 Configuring information source on the switch
By this configuration, you can define the information that sent to console terminal
is generated by which modules, information type, information level, and so on.
Perform the following configuration in system view.
Tab le 771 Enable/disable information center
Operation Command
Enable information center info-center enable
Disable information center undo info-center enable
Tab le 772 Configure to output information to the loghost
Operation Command
Output information to the loghost
info-center loghost { source interface-type
interface-number | host-ip-addr [ channel {
channel-number | channel-name } | facility
local-number | language { chinese | english }
]*}
Cancel the configuration of outputting
information to loghost
undo info-center loghost host-ip-addr
Tab le 773 Define information source
Operation Command
Define information source
info-center source { modu-name | default }
channel { channel-number | channel-name } [
debug { level severity | state state }* | log {
level severity | state state }* | trap { level
severity | state state }* ]*