3Com Switch 8800 Family Configuration Guide

822 CHAPTER 71: INFORMATION CENTER
4 Enable terminal display function
To view the output information at the console terminal, you must first enable the
corresponding log, debugging and trap information functions at the switch.
For example, if you have set the log information as the information sent to the
console terminal, now you need to use the terminal logging command to enable
the terminal display function of log information on the switch, then you can view
the information at the console terminal.
Perform the following configuration in user view:
By default, the terminal display function of debugging information is disabled.
Sending the
Configuration
Information to Telnet
Terminal or Dumb
Termina l
To send configuration information to Telnet terminal or dumb terminal, follow the
steps below:
1 Enabling information center
Perform the following configuration in system view.
Tabl e 777 Configure the output format of time-stamp
Operation Command
Configure the output format of the
time-stamp
info-center timestamp { log | trap |
debugging } { boot | date | none }
Output time-stamp is disabled
undo info-center timestamp { log | trap |
debugging }
Tabl e 778 Enable terminal display function
Operation Command
Enable terminal display function of debugging
information
terminal debugging
Disable terminal display function of
debugging information
undo terminal debugging
Enable terminal display function of log
information
terminal logging
Disable terminal display function of log
information
undo terminal logging
Enable terminal display function of trap
information
terminal trapping
Disable terminal display function of trap
information
undo terminal trapping
Tabl e 779 Enable/disable Information center
Operation Command
Enable information center info-center enable
Disable information center undo info-center enable