3Com Switch 8800 Family Configuration Guide

Information Center Function 825
Sending the
Configuration
Information to the Log
Buffer
To send configuration information to the log buffer, follow the steps below:
1 Enabling information center
Perform the following configuration in system view.
n
Information center is enabled by default. After information center is enabled,
system performances are affected when the system processes much information
because of information classification and outputting.
2 Configuring to output information to the log buffer
Perform the following configuration in system view.
By default, the switch outputs information to the log buffer in the CPU. The size of
the log buffer is 512, that is, the log buffer can hold up to 512 messages.
3 Configuring information source on the switch
By this configuration, you can define the information that sent to log buffer is
generated by which modules, information type, information level, and so on.
Perform the following configuration in system view:
Enable terminal display function of trap
information
terminal trapping
Disable terminal display function of trap
information
undo terminal trapping
Table 783 Enable terminal display function
Operation Command
Tab le 784 Enable/disable information center
Operation Command
Enable information center info-center enable
Disable information center undo info-center enable
Tab le 785 Configure to output information to log buffer
Operation Command
Output information to log buffer
info-center logbuffer [ channel {
channel-number | channel-name } | size
buffersize ]*
Cancel the configuration of outputting
information to log buffer
undo info-center logbuffer [ channel | size
]