3Com Switch 8800 Family Configuration Guide

826 CHAPTER 71: INFORMATION CENTER
modu-name specifies the module name; default represents all the modules; all
represents all the information filter configuration in channel channel-number
except default; level refers to the severity levels; severity specifies the severity level
of information. The information with the level below it will not be output.
channel-number specifies the channel number and channel-name specifies the
channel name.
When defining the information sent to log buffer, channel-number or
channel-name must be set to the channel that corresponds to logbuffer direction.
Every channel has been set with a default record, whose module name is default
and the module number is 0xffff0000. However, for different channels, the default
record may have different default settings of log, trap and debugging. When there
is no specific configuration record for a module in the channel, use the default
one.
n
If you want to view the debugging information of some modules on the switch,
you must select debugging as the information type when configuring
information source, meantime using the debugging command to turn on the
debugging switch of those modules.
You can use the following commands to configure log information, debugging
information and the time-stamp output format of trap information.
Perform the following configuration in system view:
Sending the
Configuration
Information to the Trap
Buffer
To send configuration information to the trap buffer, follow the steps below:
1 Enabling information center
Perform the following configuration in system view.
Tabl e 786 Define information source
Operation Command
Define information source
info-center source { modu-name | default }
channel { channel-number | channel-name } [
debug { level severity | state state }* | log {
level severity | state state }* | trap { level
severity | state state }* ]*
Cancel the configuration of information
source
undo info-center source { modu-name |
default | all } channel { channel-number |
channel-name }
Tabl e 787 Configure the output format of time-stamp
Operation Command
Configure the output format of the
time-stamp
info-center timestamp { log | trap |
debugging } { boot | date | none }
Output time-stamp is disabled
undo info-center timestamp { log | trap |
debugging }