3Com Switch 8800 Family Configuration Guide

828 CHAPTER 71: INFORMATION CENTER
Every channel has been set with a default record, whose module name is default
and the module number is 0xffff0000. However, for different channels, the default
record may have different default settings of log, trap and debugging. When there
is no specific configuration record for a module in the channel, use the default
one.
n
If you want to view the debugging information of some modules on the switch,
you must select debugging as the information type when configuring
information source, meantime using the debugging command to turn on the
debugging switch of those modules.
You can use the following commands to configure log information, debugging
information and the time-stamp output format of trap information.
This configuration will affect the timestamp of the displayed information.
Perform the following configuration in system view:
Sending the
Configuration
Information to SNMP
Network Management
To send configuration information to SNMP NM, follow the steps below:
1 Enabling information center
Perform the following configuration in system view.
n
Information center is enabled by default. After information center is enabled,
system performances are affected when the system processes much information
because of information classification and outputting.
2 Configuring to output information to SNMP NM
Perform the following configuration in system view.
Tabl e 791 Configure the output format of time-stamp
Operation Command
Configure the output format of the
time-stamp
info-center timestamp { log | trap |
debugging } { boot | date | none }
Output time-stamp is disabled
undo info-center timestamp { log | trap |
debugging }
Tabl e 792 Enable/disable information center
Operation Command
Enable information center info-center enable
Disable information center undo info-center enable
Tabl e 793 Configure to output information to SNMP NM
Operation Command
Output information to SNMP NM
info-center snmp channel { channel-number
| channel-name }