3Com Switch 8800 Family Configuration Guide

13
ETHERNET PORT CONFIGURATION
Ethernet Port
Overview
Switch 8800 Family series can provide conventional Ethernet ports, fast Ethernet
ports, 1000 Mbps Ethernet ports and 10 Gbps Ethernet ports. The configurations
of these Ethernet ports are basically the same, which will be described in the
following sections.
Ethernet Port
Configuration
The following sections describe Ethernet port configuration tasks:
■ “Entering Ethernet Port View”
■ “Enabling/Disabling an Ethernet Port”
■ “Setting Ethernet Port Description”
■ “Setting the Duplex Attribute of the Ethernet Port”
■ “Setting Speed on the Ethernet Port”
■ “Setting the Cable Type for the Ethernet Port”
■ “Enabling/Disabling Flow Control for the Ethernet Port”
■ “Setting the Interval of Performing Statistics on Ports”
■ “Enabling/Disabling Jumbo Frames’ Passing a Card”
■ “Setting Broadcast/Multicast Suppression on Ethernet Port”
■ “Setting the Ethernet Port Mode”
■ “Setting the Link Type for the Ethernet Port”
■ “Adding the Ethernet Port to Specified VLANs”
■ “Setting the Default VLAN ID for the Ethernet Port”
■ “Setting the VLAN VPN Feature on a Port”
■ “Copying Port Configurations to Other Ports”
■ “Setting Port Hold Time”
■ “Setting the Ethernet Port in Loopback Mode”
Entering Ethernet Port
View
Before configuring the Ethernet port, enter Ethernet port view first.
Perform the following configuration in system view.
Tab le 67 Entering Ethernet port view
Operation Command
Enter Ethernet port view interface interface-type interface-number