3Com Switch 8800 Family Firewall Module Configuration and Command Reference Guide

Log Configuration Example 187
[3Com-Vlan-interface30] ip address 30.0.0.1 24
[3Com-Vlan-interface30] quit
# Configure the static route.
[SW8800] ip route-static 0.0.0.0 0 30.0.0.254
# Configure the aggregation of the Firewall module interface (the module resides
in slot 2).
[SW8800] secblade aggregation slot 2
# Create a SecBlade test.
[SW8800] secblade test
# Specify the Firewall module interface VLAN.
[3Com-secblade-test] secblade-interface vlan-interface 30
# Set the protected VLAN.
[3Com-secblade-test] security-vlan 50 60
# Map the module to the specified slot.
[3Com-secblade-test] map to slot 2
[3Com-secblade-test] quit
[SW8800] quit
# Log into the module on the specified slot.
<SW8800> secblade slot 2 (Both the default user name and password ar
e
SecBlade)
user: SecBlade
password: SecBlade
<secblade> system-view
# Create the sub-interface.
[secblade] interface GigabitEthernet 0/0.1
[secblade-GigabitEthernet0/0.1] vlan-type dot1q vid 30
[secblade-GigabitEthernet0/0.1] ip address 30.0.0.254 24
[secblade-GigabitEthernet0/0.1] quit
[secblade] interface GigabitEthernet 0/0.2
[secblade-GigabitEthernet0/0.2] vlan-type dot1q vid 50
[secblade-GigabitEthernet0/0.2] ip address 50.0.0.254 24
[secblade-GigabitEthernet0/0.2] quit
[secblade] interface GigabitEthernet 0/0.3
[secblade-GigabitEthernet0/0.3] vlan-type dot1q vid 60
[secblade-GigabitEthernet0/0.3] ip address 60.0.0.254 24
[secblade-GigabitEthernet0/0.3] quit
# Add the sub-interface of the internal network to the trust zone.
[secblade] firewall zone trust
[secblade-zone-trust] add interface GigabitEthernet 0/0.1
[secblade-zone-trust] quit