3Com Switch 8800 Family Firewall Module Configuration and Command Reference Guide

VRRP Configuration Examples 203
4 Switch 8807_B (SecBlade_B)
# Divide VLANs.
<Switch 8807_B> system-view
[Switch 8807_B] vlan 10
[Switch 8807_B-vlan10] quit
[Switch 8807_B] vlan 50
[Switch 8807_B-vlan50] quit
# Configure aggregation of two GigabitEthernet interfaces of the SecBlade
(SecBlade slot number is 2).
[Switch 8807_B] secblade aggregation slot 2
# Create a SecBlade test.
[Switch 8807_B] secblade test
# Set the protected VLAN.
[Switch 8807_B-secblade-test] security-vlan 10 50
# Map the module to the specified slot.
[Switch 8807_B-secblade-test] map to slot 2
[Switch 8807_B-secblade-test] quit
[Switch 8807_B] quit
# Log into the module on the specified slot.
<Switch 8807_B> secblade slot 2 (Both the default user name and password are
SecBlade)
user: SecBlade
password: SecBlade
<SecBlade_B> system-view
# Create the sub-interface.
[SecBlade_B] interface g0/0.1
[SecBlade_B-GigabitEthernet0/0.1] vlan-type dot1q vid 10
[SecBlade_B-GigabitEthernet0/0.1] ip address 10.0.0.2 24
[SecBlade_B-GigabitEthernet0/0.1] vrrp vrid 1 virtual-ip 10.0.0.254
[SecBlade_B-GigabitEthernet0/0.1] quit
[SecBlade_B] interface g0/0.2
[SecBlade_B-GigabitEthernet0/0.2] vlan-type dot1q vid 50
[SecBlade_B-GigabitEthernet0/0.2] ip address 50.0.0.2 24
[SecBlade_B-GigabitEthernet0/0.2] quit
# Quit Firewall module configuration view.
[SecBlade_B] quit
<SecBlade_B> quit
[Switch 8807_B]
In normal cases, SecBlade_A is responsible for gateway work, unless it is switched
off or malfunctioning. And then SecBlade_B shall take the charge. The preemption