3Com Switch 8800 Family Firewall Module Configuration and Command Reference Guide

Firewall Configuration Commands 211
Use the undo secblade aggregation slot command to cancel the configuration.
Two internal GigabitEthernet interfaces connect the Firewall module to the switch.
You can aggregate these two interfaces into a logical interface to provide broader
interface bandwidth.
By default, the interface is not aggregated. Only one GigabitEthernet interface can
be used.
n
When you use the secblade aggregation slot command to configure the
Firewall module interface aggregation, the Firewall module will occupy the
resources occupied by other aggregation groups if aggregation resources are not
sufficient.
Example
# Set the interface aggregation for the Firewall module of slot 2.
[SW8800] secblade aggregation slot 2
secblade module Syntax
secblade module sec-mod-name
undo secblade module sec-mod-name
View
System view of the switch
Parameter
sec-mod-name: Firewall module name, which must start with letters or numbers.
Description
Use the secblade module command to create a Firewall module and enter the
Firewall module view to configure the Firewall attribute.
Use the undo secblade module command to remove the Firewall module. You
cannot remove the module if it has been mapped to a Firewall module.
Example
# Enter Firewall module View.
[SW8800] secblade module newsec
[3Com-secblade-newsec]
secblade slot Syntax
secblade slot slot-number
View
User view of the switch
Parameter
slot-number: The number of slot where the Firewall module is located.