3Com Switch 8800 Family Firewall Module Configuration and Command Reference Guide

HWTACACS Configuration Commands 261
Description
Use the display stop-accounting-buffer command to view information on the
stop-accounting requests buffered in the security gateway.
Related command: reset stop-accounting-buffer, stop-accounting-buffer
enable, and retry stop-accounting.
Example
# Display information on the buffered stop-accounting requests related to the
HWTACACS scheme "3com".
<SecBlade_FW> display stop-accounting-buffer hwtacacs-scheme 3com
-------------------------------------------------------------
NO. SendTime IP Address Template
1 10 172.31.1.27 3com
-------------------------------------------------------------
Whole accounting stop packet to resend:1
hwtacacs nas-ip Syntax
hwtacacs nas-ip ip-address
undo hwtacacs nas-ip
View
System view
Parameter
ip-address: Specifies a source IP address, which must be the address of this device.
It cannot be the address of all zeros, r class D address, or network address, or an
address starting with 127.
Description
Use the hwtacacs nas-ip command to specify the source address of the
hwtacacs packet sent from NAS.
Use the undo hwtacacs nas-ip command to restore the default setting.
By specifying the source address of the hwtacacs packet, you can avoid
unreachable packets as returned from the server upon interface failure. The source
address is normally recommended to be a loopback interface address.
By default, the source address is not specified, that is, the address of the interface
sending the packet serves as the source address.
This command specifies only one source address; therefore, the newly configured
source address may overwrite the original one.
Tab le 217 Description on the fields of the display stop-accounting-buffer command
Filed Description
NO. Sequence number of the accounting stop request packet
SendTime Number of the accounting stop request packets
IP Address IP address of the TACACS server
Template Name of the HWTACACS authentication scheme