3Com Switch 8800 Family Firewall Module Configuration and Command Reference Guide

268 CHAPTER 15: AAA/RADIUS/HWTACACS CONFIGURATION COMMANDS
secondary accounting Syntax
secondary accounting ip-address [ port ]
undo secondary accounting
View
HWTACACS view
Parameter
ip-address: IP address of the server, a valid unicast address in dotted decimal
format.
port: Port number of the server, which is in the range 1 to 65,535 and defaults to
49.
Description
Use the secondary accounting command to configure a secondary TACACS
accounting server.
Use the undo secondary accounting command to delete the configured
secondary TACACS accounting server.
By default, IP address of TACACS accounting server is 0.0.0.0.
You are not allowed to assign the same IP address to both primary and secondary
accounting servers.
You can configure only one secondary accounting server in a HWTACACS scheme.
If you repeatedly use this command, the latest configuration replaces the previous
one.
You can remove an accounting server only when it is not being used by any active
TCP connections, and the removal impacts only packets forwarded afterwards.
Example
# Configure a secondary accounting server.
[SecBlade_FW] hwtacacs scheme test1
[SecBlade_FW-hwtacacs-test1] secondary accounting 10.163.155.12 49
secondary
authentication
Syntax
secondary authentication ip-address [ port ]
undo secondary authentication
View
HWTACACS view
Parameter
ip-address: IP address of the server, a valid unicast address in dotted decimal
format.