3Com Switch 8800 Family Firewall Module Configuration and Command Reference Guide

HWTACACS Configuration Commands 271
undo timer quiet
View
HWTACACS view
Parameter
minutes: Ranges from 1 to 255 minutes.
Description
Use the timer quiet command to set the duration that a primary server must wait
before it can resume the active state.
Use the undo timer quiet command to restore the default (five minutes).
By default, the primary server must wait five minutes before it resumes the active
state.
Related command: display hwtacacs.
Example
# Set the quiet timer for the primary server to ten minutes.
[SecBlade_FW] hwtacacs scheme test1
[SecBlade_FW-hwtacacs-test1] timer quiet 10
timer
realtime-accounting
Syntax
timer realtime-accounting minutes
undo timer realtime-accounting
View
HWTACACS view
Parameter
minutes: Real-time accounting interval, which is a multiple of 3 in the range 3 to
60 minutes.
Description
Use the timer realtime-accounting command to configure a real-time
accounting interval.
Use the undo timer realtime-accounting command to restore the default
interval.
Real-time accounting interval is necessary for real-time accounting. After an
interval value is set, the NAS transmits the accounting information of online users
to the TACACS accounting server at intervals of this value.
The setting of real-time accounting interval depends somewhat on the
performance of the NAS and the TACACS server: a shorter interval requires higher
device performance. You are therefore recommended to adopt a longer interval