3Com Switch 8800 Family Firewall Module Configuration and Command Reference Guide

326 CHAPTER 18: FIREWALL CONFIGURATION COMMANDS
[SecBlade_FW] firewall zone DMZ
[SecBlade_FW-zone-DMZ] add interface GigabitEthernet0/0.1
display zone Syntax
display zone [ zone-name ] [ interface | priority ]
View
Any view
Parameter
zone-name: Name of the security zone. There are four pre-defined security zones
in the system, which are Trust, Untrust, DMZ, and Local.
interface: Displays the interfaces in the security zone.
priority: Displays the priority of the security zone.
Description
Use the command to display the interfaces in the security zone and the priority of
the security zone.
Example
# Display the priorities of all the security zones.
<SW8800> display zone priority
local
priority is 100
#
trust
priority is 85
#
untrust
priority is 5
#
DMZ
priority is 50
#
set priority Syntax
set priority number
View
Area view
Parameter
number: Priority value of the security zone, in the range of 1 to 100.
Description
Use the set priority command to set priority value for the security zone. High
priority value means high security.