3Com Switch 8800 Family Firewall Module Configuration and Command Reference Guide

Transparent Firewall Configuration Commands 335
Example
# Display the configuration information of the transparent firewall.
<SecBlade_FW> display firewall transparent-mode config
Firewall transparent-info:
ARP learning : enable
System IP address: 169.0.0.1
System IP mask : 255.0.0.0
Unknown-mac:
Unicast IP packet : arp
broadcast IP packet: drop
Multicast IP packet: drop
display firewall
transparent-mode traffic
Syntax
display firewall transparent-mode traffic [ interface interface-type
interface-number ]
View
Any view
Parameter
interface interface-type interface-number: Displays the traffic information about
the specified interface.
Description
Use the display firewall transparent-mode traffic command to display the
traffic information about the transparent firewall.
Example
# Display the traffic information about the transparent firewall.
<SecBlade_FW> display firewall transparent-mode traffic
system error is 0,inport error is 0,
outport error is 0 ,other error is 0
the total statistic :
Input:
860 total, 0 bpdu, 750 single,
0 multi, 110 broadcast;
860 ip,0 ipx, 0 other protocol;
860 eth2, 0 snap,
0 dlsw, 0 other,
0 vlan;
Output:
747 total, 0 bpdu, 747 single,
0 multi, 0 broadcast;
747 ip, 0 ipx, 0 other protocol;
747 eth2, 0 snap,
0 dlsw, 0 other,
0 vlan;
Send way:
0 broadcast, 0 fast, 747 other
Discard:
0 by inport state,
0 for local frame ,
0 by mac table,