3Com Switch 8800 Family Firewall Module Configuration and Command Reference Guide

AAA and RADIUS/HWTACACS Protocol Configuration Example 57

# Configure the IP address.

[SW8800] interface vlan-interface 10

[3Com-Vlan-interface10] ip address 10.0.0.254 24

[3Com-Vlan-interface10] quit

[SW8800] interface vlan-interface 30

[3Com-Vlan-interface30] ip address 30.0.0.1 24

[3Com-Vlan-interface30] quit

# Configure the static route.

[SW8800] ip route-static 0.0.0.0 0 30.0.0.254

# Configure the aggregation of the module interfaces (the module resides in slot

2).

[SW8800] secblade aggregation slot 2

# Create the module test.

[SW8800] secblade module test

# Specify the module interface VLAN.

[3Com-secblade-test] secblade-interface vlan-interface 30

# Set the protected VLAN.

[3Com-secblade-test] security-vlan 50

# Map the module to the specified slot.

[3Com-secblade-test] map to slot 2

[3Com-secblade-test] quit

[SW8800] quit

# Log into the module of the specified slot.

<SW8800> secblade slot 2 (Both the default user name and password are SecBlade)

user: SecBlade

password: SecBlade

<secblade> system-view

# Create the sub-interface.

[secblade] interface GigabitEthernet 0/0.1

[secblade-GigabitEthernet0/0.1] vlan-type dot1q vid 30

[secblade-GigabitEthernet0/0.1] ip address 30.0.0.254 24

[secblade-GigabitEthernet0/0.1] quit

[secblade] interface GigabitEthernet 0/0.2

[secblade-GigabitEthernet0/0.2] vlan-type dot1q vid 50

[secblade-GigabitEthernet0/0.2] ip address 50.0.0.254 24

[secblade-GigabitEthernet0/0.2] quit

# Add the sub-interface of the internal network to the trust zone.