3Com Switch 8800 Family IPsec Module Configuration and Command reference Guide

14 CHAPTER 2: IPSEC MODULE CONFIGURATION
By default, the IPsec module is not created.
Specifying the Layer 3
Interface Connecting the
Switch and IPsec module
To make the IPsec module and Switch 8800 Family switch communicate at Layer 3,
you must specify the Layer 3 interface connecting the switch and the IPsec
module.
Perform the following configuration in IPsec module view of the switch.
By default, the Layer 3 interface connecting the switch and IPsec module is not
configured.
Specifying the VLAN
Protected by the IPsec
module
To make the IPsec module protect the data stream of the specific VLAN, you need
to specify the protected VLAN.
Perform the following configuration in IPsec module view of the switch.
By default, no VLAN is protected.
Mapping the IPsec
module to a slot
After implementing the above configuration on the IPsec module, you need to
map this module to the slot to apply the configuration.
Perform the following configuration in IPsec module view of the switch.
By default, the IPsec module is not mapped to the IPsec module.
Logging into the IPsec
module
You can directly log into the IPsec module card through the Switch 8800 to
configure and manage the card.
Perform the following configuration in switch user view
Tabl e 4 Specify the Layer 3 interface connecting the switch and the IPsec module
Command Command
Specify the Layer 3 interface connecting
the switch and the IPsec module
secblade-interface vlan-interface
Cancel the configuration
undo secblade-interface vlan-interface
interface-number
Tabl e 5 Specify the VLAN protected by the IPsec module
Operation Command
Specify the protected VLAN security-vlan vlan-range
Cancel the VLAN protection undo security-vlan vlan-range
Tabl e 6 Map the IPsec module to the IPsec module
Operation Command
Map the IPsec module to the
IPsec module
map to slot slot-number
Cancel the configuration undo map to slot slot-number