3Com Switch 8800 Family IPsec Module Configuration and Command reference Guide

PKI Configuration Example 201
<SW8800> system-view
[SW8800] vlan 10
[3Com-vlan10] quit
[SW8800] vlan 30
[3Com-vlan30] quit
[SW8800] vlan 50
[3Com-vlan50] quit
# Configure the IP address.
[SW8800] interface vlan-interface 10
[3Com-Vlan-interface10] ip address 10.0.0.254 24
[3Com-Vlan-interface10] quit
[SW8800] interface vlan-interface 30
[3Com-Vlan-interface30] ip address 30.0.0.1 24
[3Com-Vlan-interface30] quit
# Configure the static route.
[SW8800] ip route-static 0.0.0.0 0 30.0.0.254
# Configure aggregation of IPsec module interfaces (the module resides in slot 2).
[SW8800] secblade aggregation slot 2
# Create the SecBlade test.
[SW8800] secblade module test
# Specify an IPsec module interface VLAN.
[3Com-secblade-test] secblade-interface vlan-interface 30
# Set the protected VLAN.
[3Com-secblade-test] security-vlan 50
# Map the IPsec module to the IPsec module of the specified slot.
[3Com-secblade-test] map to slot 2
[3Com-secblade-test] quit
[SW8800] quit
# Log into the IPsec module of the specified slot.
<SW8800> secblade slot 2 (Both the default user name and password are secblade)
Username:secblade
Password:secblade
<secblade> system-view
# Create the sub-interface.
[secblade] interface GigabitEthernet 0/0.1
[secblade-GigabitEthernet0/0.1] vlan-type dot1q vid 30
[secblade-GigabitEthernet0/0.1] ip address 30.0.0.254 24
[secblade-GigabitEthernet0/0.1] quit
[secblade] interface GigabitEthernet 0/0.2
[secblade-GigabitEthernet0/0.2] vlan-type dot1q vid 50