3Com Switch 8800 Family IPsec Module Configuration and Command reference Guide

216 CHAPTER 13: DVPN
Perform the following configuration in Tunnel interface view on a client or a DVPN
server.
A Tunnel interface is not configured with a DVPN ID.
Configuring the source end address of the Tunnel interface
The source address or source interface refers to address of the interface DVPN
packets sourced from. The source end address along with the destination address,
which must be configured on both the server end and the client end respectively,
uniquely identify a Tunnel. The two addresses are source and destination addresses
mutually.
Perform the following configuration in Tunnel interface view on a client or a DVPN
server.
Configuring the DVPN class to be applied to the Tunnel interface (client
side only)
After configuring the DVPN server in a DVPN class view on the client side, perform
the following operations to apply the DVPN class.
Perform the following configuration in Tunnel interface view on the client side.
A Tunnel interface does not have a DVPN class applied by default.
Configuring the DVPN policy to be applied to the Tunnel interface (server
side only)
After configuring the policy in a DVPN policy view on the server side, perform the
following operations to apply it to the DVPN domain.
Perform the following configuration in Tunnel interface view on the server side.
Tabl e 226 Configure the DVPN domain the Tunnel interface belongs to
Operation Command
Configure the DVPN domain the Tunnel
interface belongs to
dvpn dvpn-id dvpn-id
Revert the Tunnel interface to the default undo dvpn dvpn-id
Tabl e 227 Configure the source end address of the Tunnel interface
Operation Command
Configure the source end address or source
interface of the Tunnel interface
source { ip-address | interface-type
interface-number }
Remove the source end address or the source
interface of the Tunnel interface
undo source
Tabl e 228 Configure/Remove the DVPN class to be applied to the Tunnel interface
Operation Command
Configure the DVPN class to be applied to the
Tunnel interface
dvpn server dvpn-class-name
Remove the DVPN class applied to the Tunnel
interface
undo dvpn server dvpn-class-name