3Com Switch 8800 Family IPsec Module Configuration and Command reference Guide

226 CHAPTER 13: DVPN
# Map the IPsec module to the IPsec module of the specified slot.
[3Com-secblade-test] map to slot 2
[3Com-secblade-test] quit
[SW8800] quit
# Log into the IPsec module of the specified slot.
<SW8800> secblade slot 2 (Both user name and password are SecMBlade)
user: SecBlade
password: SecBlade
<secblade_Clnt1> system-view
# Create a sub-interface.
[secblade_Clnt1] interface g0/0.1
[secblade_Clnt1-GigabitEthernet0/0.1] vlan-type dot1q vid 30
[secblade_Clnt1-GigabitEthernet0/0.1] ip address 30.0.0.254 24
[secblade_Clnt1-GigabitEthernet0/0.1] quit
[secblade_Clnt1] interface g0/0.2
[secblade_Clnt1-GigabitEthernet0/0.2] vlan-type dot1q vid 50
[secblade_Clnt1-GigabitEthernet0/0.2] ip address 50.0.0.254 24
[secblade_Clnt1-GigabitEthernet0/0.2] quit
# Configure a static route.
[secblade_Clnt1] ip route-static 10.0.0.0 24 30.0.0.1
# Enable DVPN function.
[secblade_Clnt1] dvpn service enable
# Configure dvpn-class.
[secblade_Clnt1] dvpn class testserver
[secblade_Clnt1-dvpn-class-testserver] public-ip 90.0.0.254
[secblade_Clnt1-dvpn-class-testserver] quit
# Configure attribute for Tunnel 0 interface.
[secblade_Clnt1] interface tunnel 0
[secblade_Clnt1-Tunnel0] ip address 192.168.0.1 255.255.255.0
[secblade_Clnt1-Tunnel0] tunnel-protocol udp dvpn
[secblade_Clnt1-Tunnel0] source GigabitEthernet0/0.2
[secblade_Clnt1-Tunnel0] dvpn interface-type client
[secblade_Clnt1-Tunnel0] dvpn server testserver
[secblade_Clnt1-Tunnel0] dvpn dvpn-id 1
[secblade_Clnt1-Tunnel0] quit
# Configure the static route.
[secblade_Clnt1] ip route-static 70.0.0.0 255.255.255.0 192.168.0.254
[secblade_Clnt1] ip route-static 20.0.0.0 255.255.255.0 192.168.0.2
3 Configure client 2
Switch 8800 Family switches