3Com Switch 8800 Family IPsec Module Configuration and Command reference Guide

IPsecModule Configuration Commands 251
Description
Use the secblade aggregation slot command to configure SecBlade interface
aggregation.
Use the undo secblade aggregation slot command to cancel the configuration.
Two internal GigabitEthernet interfaces connect the SecBlade card to the switch.
You can aggregate these two interfaces into a logical interface to provide broader
interface bandwidth.
By default, the interface is not aggregated. Only one GigabitEthernet interface can
be used.
n
When you use the secblade aggregation slot command to configure SecBlade
interface aggregation, the SecBlade will occupy the resources occupied by other
aggregation groups if aggregation resources are not enough.
Example
# Set interface aggregation for the SecBlade card of slot 2.
[SW8800] secblade aggregation slot 2
secblade module Syntax
secblade module sec-mod-name
undo secblade module sec-mod-name
View
System view of the switch
Parameter
sec-mod-name: SecBlade module name, which must start with letters or numbers.
Description
Use the secblade module command to create an SecBlade module and enter
SecBlade module view to configure SecBlade module attribute.
Use the undo secblade module command to remove the SecBlade module. You
cannot remove the module if it has been mapped to a SecBlade card.
Example
# Enter SecBlade module view.
[SW8800] secblade module newsec
[3Com-secblade-newsec]
secblade slot Syntax
secblade slot slot-number
View
User view of the switch