3Com Switch 8800 Family IPsec Module Configuration and Command reference Guide

252 CHAPTER 16: IPSEC MODULE CONFIGURATION COMMANDS
Parameter
slot-number: The number of slot where the SecBlade card is located.
Description
Use the secblade slot command to log into the SecBlade card.
Example
# Log into the SecBlade card in slot 2.
<SW8800> secblade slot 2
secblade-interface Syntax
secblade-interface vlan-interface interface-number
undo secblade-interface vlan-interface interface-number
View
SecBlade module view of the switch
Parameter
interface-number: Number of the specified interface.
Description
Use the secblade-interface command to set an interface as a Layer 3 interface
connecting the switch and SecBlade.
Use the undo secblade-interface command to cancel the configuration.
By default, the Layer 3 interface connecting the switch and SecBlade is not
configured.
The VLAN which the specified VLAN interface corresponds to cannot belong to the
security-vlan.
Example
# Set the VLAN interface 40 of the switch as the Layer 3 interface connecting the
switch and SecBlade module.
[3Com-secblade-newsec] secblade-interface vlan-interface 40
security-vlan Syntax
security-vlan vlan-range
undo security-vlan vlan-range
View
SecBlade module view of the switch
Parameter
vlan-range: VLAN range.