3Com Switch 8800 Family IPsec Module Configuration and Command reference Guide

RADIUS Protocol Configuration Commands 271
Parameter
active: Configured to allow users in the current ISP domain or the current local
user to request for network services.
block: Configured to block users in the current ISP domain or the current local
user to request for network services.
Description
Use the state command to configure the state of the current ISP domain or local
user.
By default, both ISP domain (in ISP domain view) and local user (in local user view)
are in the active state upon their creation (in ISP domain view).
Every ISP domain can be active or blocked. If an ISP domain is configured to be
active, the supplicants in it can request for network services; whereas in the block
state, its users are disallowed to request for any network service, which does not
affect the users currently online. This is also applies to local users.
Related command: domain.
Example
# Set the state of the current ISP domain "3com163.net" to block. The supplicants
in this domain cannot request for network services.
[SecBlade_FW-isp-3com163.net] state block
# Set the state of the user "3com1" to block.
[SecBlade_FW-luser-3com1] state block
RADIUS Protocol
Configuration
Commands
accounting optional Syntax
accounting optional
undo accounting optional
View
RADIUS domain view
Parameter
None
Description
Use the accounting optional command to enable optional accounting.
Use the undo accounting optional command to disable it.
By default, the optional accounting is disabled.