3Com Switch 8800 Family IPsec Module Configuration and Command reference Guide

280 CHAPTER 17: AAA/RADIUS/HWTACACS CONFIGURATION COMMANDS
View
Any view
Parameter
radius-scheme radius-scheme-name: Displays information on buffered
stop-accounting requests related to the RADIUS scheme specified by
radius-scheme-name. It is a string not exceeding 32 characters and excluding
forward slashes (/), colons (:), asterisks (*), question marks (?), less-than signs (<),
and greater-than signs (>).
session-id session-id: Displays information on the buffered stop-accounting
requests related to the session ID specified by session-id, a string of up to 50
characters.
time-range start-time stop-time: Displays the buffered stop-accounting requests
by the time range of requests. It is specified by start-time and stop-time in the
format of hh:mm:ss-mm/dd/yyyy or hh:mm:ss-yyyy/mm/dd, that is,
hours:minutes:seconds-months/days/years or
hours:minutes:seconds-years/months/days.
user-name user-name : Displays information on the buffered stop-accounting
requests by user name.
Description
Use the display stop-accounting-buffer command to view information on the
stop-accounting requests buffered in the security gateway by RADIUS scheme,
session ID, or time range. The displayed packet information can help you
troubleshoot RADIUS faults.
If receiving no response after sending a stop-accounting request to a RADIUS
server, the security gateway buffers the request packet and retransmits it. The
number of allowed transmission attempts can be set using the retry
stop-accounting command.
Related command: reset stop-accounting-buffer, stop-accounting-buffer
enable, and retry stop-accounting.
Example
# Display information on the buffered stop-accounting requests between 0:0:0
and 23:59:59 on August 31, 2002.
<SecBlade_FW> display stop-accounting-buffer time-range 0:0:0-08/31/2002
23:59:59-08/31/2002
Total find 0 record
key Syntax
key { accounting | authentication } string
undo key { accounting | authentication }
View
RADIUS view