3Com Switch 8800 Family IPsec Module Configuration and Command reference Guide

290 CHAPTER 17: AAA/RADIUS/HWTACACS CONFIGURATION COMMANDS
Parameter
retry-times: Specifies the maximal retransmission times after stop-accounting
request,. ranging from 10 to 65535.
Description
Use the retry stop-accounting command to configure the maximal
retransmission times after stop-accounting request.
Use the undo retry stop-accounting command to restore the retransmission
times to the default value.
Because the stop-accounting request concerns account balance and will affect the
amount of charge, which is very important for both the user and ISP, NAS shall
make its best effort to send the message to RADIUS accounting server.
Accordingly, if the message from the security gateway to RADIUS accounting
server has not been responded, the security gateway shall save it in the local
buffer and retransmit it until the server responds or discard the messages after
transmitting for specified times.
Related command: reset stop-accounting-buffer, radius scheme, display
stop-accounting-buffer.
The default maximal retransmission times after stop-accounting request is 500.
Example
# Indicate that, when stop-accounting request for the server in the RADIUS
scheme "3com", the security gateway system will retransmit the packets for up to
1000 times.
[SecBlade_FW-radius-3com] retry stop-accounting 1000
secondary accounting Syntax
secondary accounting ip-address [ port-number ]
undo secondary accounting
View
RADIUS view
Parameter
ip-address: IP address, in dotted decimal format. By default, the IP address of
secondary accounting server is at 0.0.0.0.
port-number: Specifies the UDP port number, ranging from 1 to 65535. By
default, the accounting service is provided through UDP 1813.
Description
Use the secondary accounting command to configure the IP address and port
number for the secondary RADIUS accounting server.
Use the undo secondary accounting command to restore the IP address and
port number to the defaults.