3Com Switch 8800 Family IPsec Module Configuration and Command reference Guide

304 CHAPTER 17: AAA/RADIUS/HWTACACS CONFIGURATION COMMANDS
primary accounting Syntax
primary accounting ip-address [ port ]
undo primary accounting
View
HWTACACS view
Parameter
ip-address: IP address of the server, a valid unicast address in dotted decimal
format.
port: Port number of the server, which is in the range 1 to 65,535 and defaults to
49.
Description
Use the primary accounting command to configure a primary TACACS
accounting server.
Use the undo primary accounting command to delete the configured primary
TACACS accounting server.
By default, IP address of TACACS accounting server is 0.0.0.0.
You are not allowed to assign the same IP address to both primary and secondary
accounting servers.
You can configure only one primary accounting server in a HWTACACS scheme. If
you repeatedly use this command, the latest configuration replaces the previous
one.
You can remove an accounting server only when it is not being used by any active
TCP connections, and the removal impacts only packets forwarded afterwards.
Example
# Configure a primary accounting server.
[SecBlade_FW] hwtacacs scheme test1
[SecBlade_FW-hwtacacs-test1] primary accounting 10.163.155.12 49
primary authentication Syntax
primary authentication ip-address [ port ]
undo primary authentication
View
HWTACACS view
Parameter
ip-address: IP address of the server, a valid unicast address in dotted decimal
format.