3Com Switch 8800 Family IPsec Module Configuration and Command reference Guide

HWTACACS Configuration Commands 305
port: Port number of the server, which is in the range 1 to 65535 and defaults to
49.
Description
Use the primary authentication command to configure a primary TACACS
authentication server.
Use the undo primary authentication command to delete the configured
authentication server.
By default, IP address of TACACS authentication server is 0.0.0.0.
You are not allowed to assign the same IP address to both primary and secondary
authentication servers.
You can configure only one primary authentication server in a HWTACACS
scheme. If you repeatedly use this command, the latest configuration replaces the
previous one.
You can remove an authentication server only when it is not being used by any
active TCP connections, and the removal impacts only packets forwarded
afterwards.
Related command: display hwtacacs.
Example
# Configure a primary authentication server.
[SecBlade_FW] hwtacacs scheme test1
[SecBlade_FW-hwtacacs-test1] primary authentication 10.163.155.13 49
primary authorization Syntax
primary authorization ip-address [ port ]
undo primary authorization
View
HWTACACS view
Parameter
ip-address: IP address of the server, a valid unicast address in dotted decimal
format.
port: Port number of the server, which is in the range 1 to 65535 and defaults to
49.
Description
Use the primary authorization command to configure a primary TACACS
authorization server.
Use the undo primary authorization command to delete the configured primary
authorization server.