3Com Switch 8800 Family IPsec Module Configuration and Command reference Guide

310 CHAPTER 17: AAA/RADIUS/HWTACACS CONFIGURATION COMMANDS
You are not allowed to assign the same IP address to both primary and secondary
authorization servers.
You can configure only one primary authorization server in a HWTACACS scheme.
If you repeatedly use this command, the latest configuration replaces the previous
one.
You can remove an authorization server only when it is not being used by any
active TCP connections, and the removal impacts only packets forwarded
afterwards.
Related command: display hwtacacs.
Example
# Configure the secondary authorization server.
[SecBlade_FW] hwtacacs scheme test1
[SecBlade_FW-hwtacacs-test1] secondary authorization 10.163.155.13 49
stop-accounting-buffer
enable
Syntax
stop-accounting-buffer enable
undo stop-accounting-buffer enable
View
HWTACACS view
Parameter
None
Description
Use the stop-accounting-buffer enable command to buffer the
stop-accounting request packets with no response on the security gateway.
Use the undo stop-accounting-buffer enable command to forbid buffering the
stop-accounting request packets with no response on the security gateway.
By default, the stop-accounting request packets with no response can be buffered
on the security gateway.
For the detailed description, refer to the stop-accounting-buffer enable
command in the RADIUS scheme.
Example
# For the server in the HWTACACS scheme named "3com", allow the
stop-accounting request packets with no response to be buffered on the security
gateway system.
[3Com-hwtacacs-test] stop-accounting-buffer enable
timer quiet Syntax
timer quiet minutes