3Com Switch 8800 Family IPsec Module Configuration and Command reference Guide

20
L2TP CONFIGURATION COMMANDS
n
The content below applies to the IPsec module, so the command views in thi
document apply to the module and not the Switch 8800 Family switches.
allow l2tp Syntax
allow l2tp virtual-template virtual-template-number remote remote-name [
domain domain-name ]
undo allow
View
L2TP group view
Parameter
virtual-template-number: Specifies the virtual template interface used when
creating new virtual access interface, an integer ranging from 0 to 1023.
remote-name: Specifies the name of the peer end of the tunnel that initiates the
connection request, a case sensitive character string with length ranging from 1 to
30.
domain-name: Specifies the name of enterprise with length ranging from 1 to 30.
Description
Use the allow l2tp command to specify the name of the peer end of the tunnel
on receiving call and the Virtual-Template it uses.
Use the undo allow command to remove the name of the peer end of the tunnel
and the Virtual-Template it uses.
By default, call receiving is disabled.
This command is used on LNS side.
For multi-instance applications of L2TP, the domain-name parameter must be
configured.
When L2TP group number1 (the default L2TP group number) is used, the name of
the peer end of the tunnel remote-name can be unspecified. When configured in
the view of L2TP group 1, the format of the command is as follows:
allow l2tp virtual-template virtual-template-number [ remote remote-name ] [
domain domain-name ]