3Com Switch 8800 Family IPsec Module Configuration and Command reference Guide

342 CHAPTER 20: L2TP CONFIGURATION COMMANDS
Description
Use the display l2tp tunnel command to display information of the current L2TP
tunnels.
The output information of the command facilitates the user to learn information
of the current L2TP tunnels.
Related command: display l2tp session.
Example
# Display information of the current L2TP tunnels.
<SecBlade VPN> display l2tp tunnel
LocalTID RemoteTID RemoteAddress Port Sessions RemoteName keepstanding
2 22849 11.1.1.1 1701 1 lns YES
Total tunnel = 1
n
When the security gateway is used as LNS and domain users and non-domain
users exist, wrong L2TP information may be displayed on the device for a tunnel
triggered by a non-domain user.
display l2tp user Syntax
display l2tp user
View
Any view
Parameter
None
Description
Use the display l2tp user command to display information about current L2TP
users.
Related command: display l2tp tunnel, display l2tp session.
Example
# Display information about current L2TP users.
Tabl e 266 Description on the fields of the display l2tp tunnel command
Field Description
Total tunnels Number of tunnels
LocalTID The number uniquely identifies the local tunnel
RemoteTID The number uniquely identifies the peer tunnel
Remote Name Name of the peer end
RemoteAddress IP address of the peer end
Port Port number of the peer end
Sessions Number of sessions on the tunnel
Remote Name Name of the peer
KeepStanding State of the tunnel-hold function