3Com Switch 8800 Family IPsec Module Configuration and Command reference Guide

348 CHAPTER 20: L2TP CONFIGURATION COMMANDS
Description
Use the reset l2tp tunnel command to clear the specified tunnel connection and
all sessions on the tunnel.
The tunnel connection compulsorily disconnected by the reset l2tp tunnel
command can be reestablished again when the remote user calls in again. You
may specify tunnel connections to be disconnected by specifying remote name. If
no such tunnel connections exist, the current tunnel connections will not be
affected. If there are several tunnel connections (with the same name but different
IP addresses), all of them will be cleared. When tunnel-id is specified, only the
corresponding tunnel connection will be disconnected.
Related command: display l2tp tunnel.
Example
# Clear the tunnel connection with the peer name of AS8010.
<SecBlade VPN> reset l2tp tunnel name AS8010
reset l2tp user Syntax
reset l2tp user user-name
View
User view
Parameter
user-name: L2TP user name.
Description
Use the reset l2tp user command to force down the L2TP connection of the
specified user. When the user calls in again, the connection can be reset up.
Related command: reset l2tp tunnel, reset l2tp session.
Example
# Force down the connection of current L2TP user.
<SecBlade VPN> reset l2tp user sw8800@3com
session idle-time Syntax
session idle-time time
undo session idle-time
View
L2TP group view
Parameter
time: Idle-timeout time in the range from 0 to 10000 seconds.