3Com Switch 8800 Family IPsec Module Configuration and Command reference Guide

Encryption Card Configuration Commands 397
undo tunnel remote [ ip-address ]
View
Manually-established IPsec policy view
Parameter
ip-address: Remote address in dotted decimal format.
Description
Use the tunnel remote command to set the remote address of an IPsec policy.
Use the undo tunnel remote command to delete the remote address in the IPsec
policy.
By default, the remote address of an IPsec policy is not configured.
For the IPsec policy in manual mode, only one remote address can be set. If a
remote address is already set, this existing address must be deleted before a new
one can be set.
The security tunnel is established between the local and remote ends. The remote
address must be set correctly on both ends of the security tunnel.
Related command: ipsec policy (system view), ipsec policy (interface view),
security acl , tunnel local, sa duration, proposal.
Example
# Set the remote address of the IPsec policy to 10.1.1.2.
[SecBlade_VPN] ipsec policy shanghai 10 manual
[SecBlade_VPN-ipsec-policy-shanghai-10] tunnel remote 10.1.1.2
Encryption Card
Configuration
Commands
debugging encrypt-card Syntax
debugging encrypt-card {all | command | error | misc | packet | sa} slot-id
undo debugging encrypt-card {all | command | error | misc | packet | sa}
slot-id
debugging encrypt-card host { all | command | error | misc | packet | sa }
undo debugging encrypt-card host { all | command | error | misc | packet | sa
}
View
User view
Parameter
all: Enables all debugging on the encryption card.