3Com Switch 8800 Family IPsec Module Configuration and Command reference Guide

Encryption Card Configuration Commands 399
display interface encrypt Syntax
display interface encrypt [ slot-id ]
View
Any view
Parameter
slot-id: Slot ID of an encryption card, whose range depends on the number of slots
on the security gateway. It is in 3-dimentional format, for example, x/y/z, where x
stands for a slot number on the security gateway, y and z are constant 0 for
encryption cards.
Description
Use the display interface encrypt command to view the information about the
encryption cards.
With this command, you can view the status of the encryption card, total number
of packets transmitted or received on it, maximum number of packets dropped
per second, and information during the last five seconds.
Related command: interface encrypt.
Example
# Display the port information on the encryption card at slot 5/0/0.
[SecBlade_VPN] display interface Encrypt 5/0/0
Description : Encrypt5/0/0 Interface
Protocol Status: READY
Driver Status : READY
Total Statistics
Packets sent to card : 10
Packets received from card : 9
Bytes sent to card : 1216
Bytes received from card : 584
Dropped packets : 0
Statistics during last 5 seconds
Packets sent to card : 0
Packets received from card : 0
Bytes sent to card : 0
Bytes received from card : 0
Dropped packets : 0
SourPort Source port
DestIP Destination IP address
DestPort Destination port
Prot Protocol number
TdbID TDB ID for encrypting this flow
Type Two options are available: encrypt (in the outgoing direction) and decrypt (in the
incoming direction)
Table 277 Description on the fields of the display encrypt-card fast-switch command
Field Description