3Com Switch 8800 Family IPsec Module Configuration and Command reference Guide

Encryption Card Configuration Commands 405
Example
# Clear all the logging information on the encryption card on the slot 5/0/0.
<SecBlade_VPN> reset encrypt-card syslog 5/0/0
snmp-agent trap enable
encrypt-card
Syntax
snmp-agent trap enable encrypt-card
undo snmp-agent trap enable encrypt-card
View
System view
Parameter
None
Description
Use the snmp-agent trap enable encrypt-card command to enable SNMP
agent trap function on encryption card.
Use the undo snmp-agent trap enable encrypt-card command to disable
SNMP agent trap function on encryption card.
By default, no ACL has been specified for the IPsec policies.
When combined with appropriate NM configuration, the trap function allow you
to view the information about card rebooting, status transition and packet loss
processing on the Console of the NM station or security gateway.
Example
# Enable the trap function on the encryption card.
[SecBlade_VPN] snmp-agent trap enable encrypt-card
use encrypt-card Syntax
use encrypt-card slot-id
undo use encrypt-card
View
Card SA proposal view
Parameter
slot-id: Slot ID of an encryption card, whose range depends on the number of slots
on the security gateway. It is in 3-dimentional format, for example, x/y/z, where x
stands for a slot number on the security gateway, y and z are constant 0 for
encryption cards.
Description
Use the use encrypt-card command to specify the SA proposal uses the
encryption card at a designated slot.